Click image for a quoteSplice Protection Sleeve 60 mm, Pack of 1000
Bulk, project or custom order?
Share your number for the best price.
| Length | 60 mm |
|---|---|
| Strength member | Stainless steel rod |
| Colour | Clear |
| Pack | 1000 pieces |
| Typical use | Protecting fusion splices in trays and closures |
Every fusion splice needs a sleeve
A bare fusion splice is strong enough to hold light but weak against bending and pulling. A splice protection sleeve slides over the joint before splicing; after the splice is made, it goes into the splicer's heater, the outer tube shrinks, and the hot-melt inner tube bonds the fibre to a steel rod. The result is a rigid, sealed joint that sits in the splice tray.
Choosing the right sleeve
- 60 mm is the standard length for most splicers and trays.
- A steel rod gives the stiffness most splice trays are designed for.
- Clear tubes let you inspect the joint after shrinking.
Check that your splicer's heater programme matches 60 mm sleeves. Sleeves for ribbon fibre or 40 mm micro-sleeves are available on request.
FAQ
Questions about this product
Do these fit my splicer?
Most fusion splicers use 60 mm sleeves. Check the heater length in your splicer settings.
Can I buy fewer than 1000?
The standard pack is 1000. Ask if you need smaller quantities.
Do you have 40 mm or ribbon sleeves?
Yes, on request.
You may also need
Related products
View & get quoteSC/APC – SC/APC Simplex Patch Cord, 3 m
View & get quoteSC/APC Pigtail 0.9 mm, 12-Colour Set
View & get quotePLC Splitter 1x8 SC/APC, ABS Box
View & get quoteFAT Box 8 Port, Outdoor IP65
Get the best quote for Splice Protection Sleeve 60 mm
Latest price, GST invoice and delivery details in one written quote.






